Clean freehub body. Attach new cassette. Attach lockring. Reattach quick release and fit wheel back onto bike. If you have a regular claw hammer and another length of chain, then you can create your own chain whip. Just drape the length of chain through the claw part of the hammer with the majority of chain going away from the handle of the hammer.
The axle is independent of the freehub. Remove set screw from side of drive side locknut. Hold non-drive side cone with cone wrench. Loosen and remove drive side locknut. Pull freehub to remove. Remove quick-release skewer. Inspect freewheel center and select correct removal tool see chart above. Reinstall quick-release skewer with skewer nut on outside of remover. Snug skewer nut against remover. Items you will need There are a few tried and true methods to remove your jammed cassette tapes.
Insert a thin, flat-head screwdriver beneath the cassette tape inside the deck. Grasp the tape with a pair of needle-nosed pliers. No Whip Needed I have a chain whip but for cassettes I just hold the cassette with a rag to protect my hand and loosen the lockring with the tool and adjustable wrench. Quicker and easier. To determine if a sprocket is a freewheel or cassette system, remove the rear wheel from the bike.
Find the tool fitting on the sprocket set. Spin the sprockets backwards. You can also notice some knurling beneath the lock ring, which aids it in place. This knurling makes noise when you loosen or tighten the ring.
If you can ask someone for help with removing your bike cassette, the better because this bike gear is known for its pretty tight placement on your bike. You would need strength and patience to blow it off. There are many helpful tutorials on YouTube, too.
Watching them may help you remove your bike cassette with no worries. Check out one of my favourite improved video tutorial s that highlight easy cassette removal.
The guy in the video also talked about the Needle Nose Pliers, which is the most ideal simple tool to use. It is worth checking out. So, how was the tutorial on how to remove bike cassette without special tools? Did you have fun following it? Learning how to remove bike cassettes without special tools is a handy skill to practice. You can save a lot from shop expenses. Tell us your experience in the comments.
Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same. If you have a regular claw hammer and another length of chain, then you can create your own chain whip. Just drape the length of chain through the claw part of the hammer with the majority of chain going away from the handle of the hammer.
Freewheel Removal Mount bike in repair stand and remove rear wheel from bike. Remove quick-release skewer. Inspect freewheel center and select correct removal tool see chart above. Reinstall quick-release skewer with skewer nut on outside of remover.
Snug skewer nut against remover. A Versatile Cassette Mounting Platform for Everyone The XD interface is designed for mountain bike applications and maintains the same hub spacing and flange locations used for 8, 9, and speed compatible HyperGlide freehub bodies.
0コメント